BTRFS-SCRUB(8)                             Btrfs Manual                            BTRFS-SCRUB(8)

       btrfs-scrub - scrub btrfs filesystem

       btrfs scrub  

       btrfs scrub is used to scrub a btrfs filesystem, which will read all data from all disks
       and verify checksums.

       cancel |
           If a scrub is running on the filesystem identified by , cancel it.

           Progress is saved in the scrub progress file and scrubbing can be resumed later using
           the scrub resume command. If a  is given, the corresponding filesystem is
           found and scrub cancel behaves as if it was called on that filesystem.

       resume [-BdqrR] [-c  -n ] |
           Resume a canceled or interrupted scrub cycle on the filesystem identified by  or
           on a given .

           Does not start a new scrub if the last scrub finished successfully.


           see scrub start.

       start [-BdqrRf] [-c  -n ] |
           Start a scrub on all devices of the filesystem identified by  or on a single
           . If a scrub is already running, the new one fails.

           Without options, scrub is started as a background process. Progress can be obtained
           with the scrub status command. Scrubbing involves reading all data from all disks and
           verifying checksums. Errors are corrected along the way if possible.

           The default IO priority of scrub is the idle class. The priority can be configured
           similar to the ionice(1) syntax using -c and -n options.


               Do not background and print scrub statistics when finished.

               Print separate statistics for each device of the filesystem (-B only).

               Quiet. Omit error messages and statistics.

               Read only mode. Do not attempt to correct anything.

               Raw print mode. Print full data instead of summary.

               Set IO priority class (see ionice(1) manpage).

               Set IO priority classdata (see ionice(1) manpage).

               Force starting new scrub even if a scrub is already running. This is useful when
               scrub stat record file is damaged.

       status [-d] |
           Show status of a running scrub for the filesystem identified by  or for the
           specified .

           If no scrub is running, show statistics of the last finished or canceled scrub for
           that filesystem or device.


               Print separate statistics for each device of the filesystem.

       btrfs scrub returns a zero exit status if it succeeds. Non zero is returned in case of

       btrfs is part of btrfs-progs. Please refer to the btrfs wiki http://btrfs.wiki.kernel.org
       for further details.


Btrfs v4.4                                  01/19/2016                             BTRFS-SCRUB(8)


Designed by SanjuD(@ngineerbabu)