BTRFS-RECEIVE(8)                           Btrfs Manual                          BTRFS-RECEIVE(8)

       btrfs-receive - receive subvolumes from stdin/file.

       btrfs receive [options] 

       Receives one or more subvolumes that were previously sent with btrfs send. The received
       subvolumes are stored into .

       btrfs receive will fail with the following case:

        1. a receiving subvolume already exists.

        2. a previously received subvolume was changed after it was received.

        3. default subvolume is changed or you don’t mount btrfs filesystem with fs tree.

       After receiving a subvolume, it is immediately set to read only.


           Enable verbose debug output. Each occurrence of this option increases the verbose
           level more.

           By default, btrfs receive uses stdin to receive the subvolumes. Use this option to
           specify a file to use instead.

           Confine the process to  using chroot.

           Terminate after receiving an  in the data stream. Without this option, the
           receiver terminates only if an error is recognized or on EOF.

           Terminate as soon as N errors happened while processing commands from the send stream.
           Default value is 1. A value of 0 means no limit.

           The root mount point of the destination fs.

           By default the mountpoint is searched in /proc/self/mounts. If you do not have /proc,
           eg. in a chroot environment, use this option to tell us where this filesystem is

       btrfs receive returns a zero exit status if it succeeds. Non zero is returned in case of

       btrfs is part of btrfs-progs. Please refer to the btrfs wiki http://btrfs.wiki.kernel.org
       for further details.

       mkfs.btrfs(8), btrfs-send(8)

Btrfs v4.4                                  01/19/2016                           BTRFS-RECEIVE(8)


Designed by SanjuD(@ngineerbabu)